Remote Turn-on Module
• Remote Turn-On Module
• Used To Turn On Remote Amplifiers
• 2 Second Delay To Prevent Turn-On Noise
• Supplies 2 Amps Of Current
• Can Drive Multiple Amps Or A Power Antenna
• Activated By Low Level Trigger Lead
Internal Product ID:
46218
NVX XTRI1
this seems to be a great product at a great price.
48
found this helpful.worked for intended purpose
for the price it worked just fine. reduced the popping noise my amp made whenever it powered on or off. didn't completely eliminate it but reduced it a good bit.
46
found this helpful.Stops pops
Prior to purchasing the NVX XTRI1, there was a constant pop whenever the audio system was turned on. Several methods had been tried to remove the pop, but it persisted. Purely by accident, the xtri1 was discovered. Once installed, the pop ceased to exist. Great product.
46
found this helpful.POP! stopper
After replacing the stock head unit in my 2012 camry with the otocam 3 unit, I would always get a pop from my speakers when the car was started. After rechecking my grounds, the pop was reduced, but would still occur. I bought this product on ebay, from sonicelectronix.com, installed it, NO POP! Just for information, I have 3 amps, a 10 channel crossover, a nvx capacitor and two 12s as my setup. Very happy with the nvx xtri1.
46
found this helpful.Works great so far.
I originally bought this to use on my fans but it's only capable of a 1 amp load not a 2 amp load as the Sonic Electronix description said. Instead I used it to power up 1 amplifier & my 3Sixty.3 that's powering the other 3 amplifiers. The soft start is ok but it's a great alternative to wiring a relay in which is what I'll be doing when I reposition my setup.
43
found this helpful.Works great!
Already have another one in my cart for my next build.
39
found this helpful.I bought this because ...
My installation had two amplifiers as well as a lead from the Antenna adapter (Scosche HAAB).
I wasn't sure if the remote output directly from the aftermarket deck (Pioneer AVH-X5700BHS) had enough of a signal for all 3 devices. So I bought this, hooked it up and everything works.
I actually have no idea whether I needed this product or not.
35
found this helpful.Does what it's suppose to.
Connected it to my auxiliary power on my car, which shuts off with the car, and no more pop! Works well!
34
found this helpful.Useful
I used the amp turn on wire to power fans using the module. It works great. Could have used a relay but this is solid state and has a led. Although the fans are low power it was nice not loading the head deck feed down. Thanks Sonic for have this option available
32
found this helpful.Great Product - Great Price - Stops the Pops
Had a problem with terrible speaker pop whenever you turn the car on after installing a high powered amp. Wasn’t sure how to install this, but eventually realized you can mount it right onto the amp’s power/ground/trigger wires in minutes. After installing this ALL SPEAKER POP IS GONE! Definitely recommended. Definitely worth it.
30
found this helpful.Best selling similar products