• 10 farad Hybrid Digital Capacitor
• Increases quality of sound
• Increases level of bass
• Platinum plated
Overall rating distribution
By feature average rating
October 30, 2013
It Rocks !!!!
I have this running in my system
1/0 wire from the engine compartment to this cap
then my 600x4 and my 1000 mono running off this
so nice to have the built in distribution block built in to it
one power wire and one ground ....everything else wires into this cap
either 1/0 or 4awg wire combinations
and with the big 3 in place running 1/0 wire I have no dim lights at all
and the sound is so clean and smooth for the mids and highs
the lows are just awesome !!!!!!
April 23, 2012
I had previously owned a Rockford Fosgate 1 Farad Capacitor of which I was thoroughly displeased with. I was also thoroughly displeased with the RFC10HB after I hooked it up as well. However, after tinkering with it, I found that I had hooked my RE-Q5 bass restoration system's power wire up to the outgoing power on the capacitor. Therefore it was getting vast peaks and valleys in power input. After I fixed the wiring I was blown away. It sounds like I have a new set of subwoofers. Much more accurate and rich sounding than with the 1 Farad. Also, I went from significant headlight dimming to none just by hooking it up. I'm not exactly sure why, and I've heard may people say that capacitors don't help with that, but hey, I'm not going to complain. As of now I have a stock alt, stock batt, and no big3 done. I would probably leave it that way too, if I wasn't planning on upgrading my amplifier. Shell out the extra money for this capacitor if you can. I paid 100 for my 1 farad, trust me... spend two times more and get something ten times better. You'll want the upgrade in the long run anyways.
August 7, 2011
There is a lot of controversy surrounding capacitors in car audio and if you are running a big enough system to warrant a capacitor you should probably be upgrading your battery and alternator as well as doing "The Big 3." That being said, I purchased this simply to level out the load placed on my car's electrical system (one constant load rather than a bunch of big ones) and to hopefully provide a little extra juice to my amp. If it reduced or eliminated headlight dimming then that was just icing on the cake.
Charging took a while, I stopped to let the resistor cool many times but when it finally got charged up I pulled the sides off (very stiff, be careful not to break anything) and attached it to the backside of my box and got everything wired up. I was blown away by the difference it made, I got a ton of extra bass and it was much tighter and more precise than it was before. I waited until dark and took it out to see what difference it would make in my headlights with stock alternator, normal battery, and The Big 3 done and with my high beams on and the volume all the way up I could not see any dimming. I let it idle to see if the drain would dim the lights when the alternator was not putting out as much power and I still did not notice any dimming. My Boston Acoustics GTA-800m used to dim my lights pretty bad, especially at idle on high beam, and now it doesn't seem to be an issue.
I bought and tested this cap as objectively as I could, I had no prior bias as to whether or not it would affect sound quality or headlight dimming and from what I have seen in my own car I highly recommend this because it gave me much better sound quality, more powerful bass, and it eliminated my headlight dimming. It seems expensive until you see and hear the results, then it becomes a bargain!
April 12, 2014
I STRONGLY SUGGEST THIS CAP I HAVE 2 ALPINE TYPE R 12'S AND A ALPINE 1100 WATT RMS AMP I USED TO HAVE A 2FARAD CAP AND MY LIGHTS ALMOST COMPLETELY WENT OUT WHEN MY BASS HIT NOW W/THE RFC10HB THEY DONT EVEN FLICKER WHEN TURNED UP TO MAX THE ONLY PROBLEM IVE HAD IS THE SCREWS GET STRIPED OR CROSS THREADED VERY EASILY BAD DESIGN THATS THE ONLY BAD THING I HAVE TO SAY THOUGH
July 14, 2013
No Question..This Cap Works!
If I had any question if capacitors work... this 10 farad cap has left me no doubts anymore. I have a 2013 Scion TC with stock alternator Big 3 done and an XS Power 4800 agm battery. Running Rockford T600 4 ch and a T1500 mono to a pair 10's and Focal on all four channels. I still felt like the bottom end was not right. It didn't stay hitting hard and somewhat muddy sounding. So, I finally coughed up the $200. Now the subs hit hard and stay hitting hard!! Even when I turn the subs up to clipping the clipping sounds cleaner, lmao. No question this cap made a significant difference. I won't bother looking into a high current alternator. I don't think it is necessary now. The cap is making up the difference without a doubt. Only complaint was it took over an hour to charge it up but it was worth the wait. IMHO if your running more than 500-750 total watts get this cap, you'll need it.
March 18, 2012
I have had this capacitor for about 8 months now and I can say this thing is awesome. I bought it for 60 bucks off one of my friends. Immediatly after installing it my bass was LOUDER and CLEANER than its ever been. Love this thing! The volt meter is great too. But dang the price is a lot!!!!
February 22, 2012
First off, I am a Rockford Fosgate fan. I own two Rockford Fosgate T-600x2 amps. They are pumping about 775 RMS a piece, for a total of 1550 watts RMS. That leads me two the two Rockford Fosgate P3DV4ohm 10's. I had already upgraded the Alternator, battery and wires. I was just really interested in getting a power source that would give the two amps steady amperage loads to stress the amps even less. This did the trick!!! I am running 1 gauge wire by Tsunami. Kinetic battery. Not the loudest system out, but enough to smash most.
February 13, 2014
Rockford Fosgate RFC10HB
This so far has been a solid capacitor. No light dimming and the sound is crystal clear. I have a p600-2 and a p450-4 hooked up to it and it handles the two amps with no problems. Looks good mounted between them too.
September 29, 2013
So far so good on this capacitor. It's by far the nicest looking capacitor out there. It works the way it should too...no dimming and my electrical system is running a high of 14.4 and so far nothing lower than a 13.6. I'm running a t1500-1bdcp to my T2 15 and its great.
June 26, 2012
I wouldnt think it would work, but i knew rockford wouldnt let me down. no need for extra batteries this will power amps up to at least 8000watts, i have a hifonics 3200 mono block with @ 12 T2 rockford fosgate, and im just like dam!!! im shacking everbodys cars and there houses when i pass. iv got noise complaints. id reccomend to anybody
Best selling similar products
• Complete 4 Gauge 2-Channel Amplifier Installation Kit
• Designed Specifically For Car Audio Systems Up to 1000 Watts RMS
• Premium Power and Ground Wire Provides Optimal Power Transfer
• 30% Copper CCA Wire
• 2 Farad Digital Capacitor
• Carbon Fiber Design
• 2000 Watt Systems
• Digital Display
• 2 Farad Capacitor with digital voltage display
• Red Digital Voltage Display
• Audible warning tones
• For Systems Up To 1200 Watts
• Bright Blue LED Voltage Display
• Improves Bass Response (SPL)
• Digital 10 Farad Capacitor
• Bright Red LED Voltage Display
• Monitor System Voltage
• 12-16 Volt Operation / 18 Volt Surge
• Louder And Cleaner Bass Response
Internal Product ID: