Wet Sounds XS-XXX V2
2000W 12" Xtreme Performance XS Series Dual 2-ohm SPL/Competition Marine Subwoofer (WetSounds)
The World's First SPL Marine Subwoofer
Leading the way for premium Marine Audio, Wet Sounds used advanced acoustical engineering and high end components to make the XS-XXXv2 the subwoofer of choice for those looking for extreme bass. With the most demanding system in mind, cutting edge computer aided design and full finite element analysis was used to give you a woofer built for extreme SPL use. Weighing in at over 30 pounds, the XS-XXXv2 is pound for pound the flagship in marine subwoofer drivers.
Premium Marine Components
High stiffness matte black polypropylene/carbon fiber/glass fiber cone, heavy duty magnetic system, and a true 3" dual voice coil are only a few of the high end components Wet Sounds utilizes to provide enthusiasts with one of the highest quality marine drivers on the market.
High Roll Rubber Surround
The XS-XXXv2 is equipped with a high roll santoprene thermoformed rubber surround to thoroughly accentuate its 12.30 millimeter Xmax. The drivers 1,000 watt RMS will only be achieved with proper excursion, and Wet Sound took no short cuts in making sure the driver will push as much air as possible.
Quality That Never Fails
The skin of the XS-XXXv2 is built on a Powder Coated gloss black cast aluminum frame, fiberglass former, and gold plated screw down binding posts. Combined with an integrated multi-part cooling system, a t yoke heat sink, and combination peripheral/pole piece venting the XS-XXXv2 is built for quality and reliability.
- 12" XS Series Dual 2-ohm SPL/Competition Marine Subwoofer
- Power Handling:
- Peak: 2,000 watts
- RMS: 1,000 watts
- Recommended power range: 500 - 1000 watts RMS
- Injection Molded High Strength Composite Cone
- Moisture Resistant Rubber Spider & Surround
- Powder Coated gloss black cast aluminum frame
- 3" Dual Voice Coil
- Frequency Response: 25 - 500Hz
- Sensitivity: 90 dB
- Top-mount depth: 6.53" (165.86mm)
- Diameter: 12.40" (314.96MM)
- Hole Cut Out: 11.26" (286.00mm)
- Optional Grille Available:
- Authorized Internet Dealer
- 2 Year Manufacturer's Warranty
- Resistance: 0.97Ω
- Sd: 0.0531 m2
- Xmax: 12.30mm
- Mms (g): 254
- Cms (uM/N): 100
- Fs: 32Hz
- Vas: 40L
- Qms: 5.19
- Qes: 0.48
- Qts: 0.44
- Bl (T*m): 10.1
- Le: 0.5 mH
- Sub Volume ( ft³): 0.159
For more information on the Thiele and Small Parameters, visit our T/S Parameters Article
Priced IndividuallyCheck out the Wet Sounds SW-65i-B Owner's Manual
Round/Circle: This is the typical and common subwoofer design. They have a round cone and are a circle in design.
Square: These woofers are able to achieve a greater cone area in a smaller space. Because of the greater surface area, some square subwoofers will be louder than a round subwoofer of the same size.
Efficiency (1w/1m) is not an accurate indicator of a subwoofer's output capability and should not be used as a comparison to other speakers or subwoofers to determine which one is "louder".
Shallow mount speakers will typically have a mounting depth of 2" or less, while shallow mount subwoofers will typically have a mounting depth of 3" or less.
Sealed: These enclosures completely enclose the air inside the box. These boxes produce a tight bass.
Ported/Vented: These enclosures have a slot of air to escape from the box. The result is a sound that has more "boom".
Bandpass: These are a combination of both sealed and ported enclosures. They can be very efficient, but require tuning for the best response.
What is in the box?
Specials with this Item
Warranty and Return Policy
Internal Product ID
Wiring Diagram Legend
Warning: The image depicted shows the resistance change when wiring multiple subwoofer terminals. Please refer to your subwoofer's owner's manual for the proper wiring of its terminals. Sonic Electronix, Inc. is not responsible for damage caused to your audio system or vehicle due to improper installation. Please call tech support at 1-877-289-7664 if you require additional assistance.