Kicker Car Amplifier Installation & Accessories

• 2-Channel Speaker to RCA Cable
• Split-Pin RCAs
• 16 Gauge Speaker Wire to RCA
• K-Grip Line & K-Grip Connectors
• Ergonomic Design • 2 Feet

• Wired bass remote controller for Kicker CX series amplifiers
• Works with DX or PX series amplifiers with remote bass jack
• Includes 19.5 ft. cable and mounting accessories

• self tapping bolt and washer
• FHS fuse holder
• gauge remote wire
• AWG butt connecter

• BT4 Pos/Neg Battery Terminal. (2) 1/0-8AWG, (1) 4-8AWG
• (2) 1/0-4 Gauge out
• 4-8 Gauge out
• Brass construction

• 2-ch speaker-to-RCA converter, LOC
• Compatible with OEM radios that have short circuit protection
• Take as much as 55 watts of input and deliver up to 8 volts of output

• Brass Construction
• (2) 1/0-8 Gauge In
• (4) 4-8 Gauge Out
• Uses Strong 5mm Screws

• 8AWG 2-Channel Amp Kit
• Top-quality Hyper-Flex power, ground and turn-on cables
• K Series speaker wire & interconnects + heavy-duty AFS fuse holder and fusing are all included

• Interconnect is Four Meters (13 Feet, 10 Inches) long
• Silver-tinned, OFC wire for superior signal clarity
• The K-Grip™ connectors offer sure grip and slip-free installation

• 2-channel active line output converter
• 2 speaker-level inputs with up to 400 watts RMS power handling
• 2 preamp-level outputs (up to 10V)

• FHS Single AFS Fuse Holder
• AFS, Mini-ANL fuse holder with one 1/0-8 Gauge input and output
• (1) 1/0-8 Gauge in
• (1) 1/0-8 Gauge out

• Interconnect is Three Meters (16 Feet, 4 Inches) long
• Silver-tinned, OFC wire for superior signal clarity
• The K-Grip™ connectors offer sure grip and slip-free installation

• 4-Output Battery Terminal Block
• Positive and negative polarity
• Versa-Gauge connection points with oversized connection screws
• Nickel-plated brass connection posts

• Interface For Smart Radios
• 25-ohm Load
• 4-Ch 20V Inputs

• P-Series PKD1 1/0AWG 2-Channel
• Complete with Full Spec wire, hardware, distribution block and fusing
• 4-8 Gauge out
• Brass construction

• GT2 Ground Termination Block, (2) 1/0-8AWG in
• Dual inputs allow for a single ground point for multiple amplifiers

• 4-way Fused AFS Distribution Block
• 4 input and 4 output connection points
• 5/16" stud connectors to accept most ring terminals
• Nickel-plated brass connection posts

• Marine Rated Power Wire
• 4 AWG

• Marine Rated Power Wire
• 4 AWG

• Controls 1-2 mono-channel amps with a 3.5mm level controller input
• Compatible with PTRTP and Hideaway powered sub enclosures
• Compatible with WXA, KEY, CXA, PXA and KPX-series amps
• Flush or surface-mountable
• Heavy-duty aluminum design with laser etching
• Single knob with high-end, metal look

• 8AWG Power Wire
• Length: 200 Ft.
• Virgin Hyper-Flex™ PVC insulation
• Easy installation that gets all your power to the amps in your system
• Color: Blue