600W 10" Power T1 Series Dual 4 ohm Subwoofer
Product highlights
• 1200W Peak
• 600W RMS
• High Excursion TPE (Thermo-Plastic Elastomer) Surround
• SWIFT Impedance Selection
• Dual Opposing Spiders
• Parabolic Triangular Cone Geometry
True Power You Can Feel
The T1D410 Power Series 10" Subwoofer by Rockford Fosgate has a peak power rating of 1200 watts and a RMS rating of 600 watts. This sub will produce some ground shaking bass and is constructed with a kevlar fiber reinforced semi pressed paper cone and a VAST santoprene rubber surround. This woofer is also equipped with Inductive Damping Heat Sink, this helps radiate heat to reduce the voice coil temperature and keeps the sub operating at a safe operating temperature when pumping out high amounts of SPL. Add some bumps in your trunk and enhance your cars stereo system with this Power Series Subwoofer.
SWIFT: Selectable Woofer Impedance Fused Termination
Making installation faster and easier, Rockford Fosgate developed SWIFT terminals. This system allows the nominal impedance of voice coils to quickly be configured in a Series or Parallel wiring configuration. Removing and inverting the center plug, a Series or Parallel wiring configuration is accomplished. The removable jumper also provides fused protection in severe overload conditions.
IDHS: Inductive Damping Heat Sink
By securing the Inductive Dampening Heat Sink (IDHS) to the top of the magnet structure, Rockford Fosgate is able to improve the efficiency of their drivers. This is accomplished by reducing the amount of distortion and back Electro-Magnetic Force (EMF). The IDHS also radiates heat to reduce the temperature in the voice coil.
Anodized Aluminum Voice Coil Former
By using an anodized aluminum voice coil former on their subwoofers, Rockford Fosgate is able to dissipate heat from the voice coil more efficiently. A hot voice coil can melt the adhesive bonds, which will lead to eventual subwoofer failure. The aluminum voice coil former acts as a heat-sink to dissipate thermal build-up on the voice coil cool during high SPL conditions.
Conforms to CEA-2031
Rockford Fosgate has built this subwoofer to conform to the CEA-2031 loudspeaker power handling industry standards. This means that you can trust the subwoofer to have the capacity to safely handle the continuous (RMS) power rating. Having a CEA-2031 power handling is important when matching a subwoofer to an amplifier because the power ratings are accurate.
Stitched Tinsel Leads
To improve the reliability and performance by reducing fatigue and possible shorting, Rockford Fosgate has stitched the tinsel leads to the spider. The multipoint periodic stitching lead wires reduce the mass of the tinsel leads to spread the stress over a greater area. This improves the reliability and performance of the subwoofer.
VAST: Vertical Attach Surround Technique
In order to increase the surface area of the cone without causing any installation issues, Rockford Fosgate designed the Vertical Attach Surround Technique (VAST). By redesigning the manner in which the surround adheres to the basket, these speakers gain up to 25% more effective radiating cone area. This improves the nominal efficiency and maximum output.
Rockford Fosgate Power T1D410
1200W Peak (600W RMS) 10" Power Series Dual 4-ohm Car Subwoofer
Quantity: 1
Priced Individually
Single 10" Sealed MDF Subwoofer Enclosure (Belva MDFS10)
10-inch Sealed Car Sub Box Made with 3/4" MDF and lined w/ Polyfil (0.77 cu ft airspace 10SQTC)
Quantity: 1
Belva BBSW127
12 Gauge 7 Meter (23 Ft) Speaker Wire (CCA)
Quantity: 1
|
(newest, current model)
|
|
(previous model, replaced by Rockford Fosgate Power T1D410 + Free 10" Enclosure and Speaker Wire)
|
This product is temporarily out of stock. May we recommend...
• Sealed enclosure with 1 10" Solo-Baric L7T Series Subwoofer
• 500 watts RMS power handling
• Final Impedance: 2-ohm
• Dimensions: 20-1/4" L x 12" H x 4-3/8" W x 7-1/4" W2
(2)
$254.96
List price $329.99
• Sealed enclosure with 1 12" Solo-Baric L7T Series Subwoofer
• 600 watts RMS power handling
• Final Impedance: 2-ohm
• Dimensions: 21.5" L x 13.75" H x 7.75" W x 4.375" W2
(9)
$297.96
List price $379.99
• Sealed enclosure with 1 10" Solo-Baric L7T Series Subwoofer
• 500 watts RMS Power Rating
• Final Impedance: 2-ohm
(3)
$280.96
List price $359.99
• Sealed downward-firing enclosure with one CompRT 10" subwoofer and passive radiator
• 3/4" medium-density fiberboard construction covered with carpet
• 2-ohm total impedance
• Frequency range: 25-500 Hz
• Power Handling: 400 watts RMS (800 watts peak power)
• sensitivity: 96.5 dB
• Dimensions: 25-5/8"W x 13-1/4"D x 5-5/8"H
(3)
$254.96
List price $329.99
• Single 10" Sealed Subwoofer Enclosure
• Preloaded with single 10" Comp Subwoofers
• 3/4" medium-density fiberboard construction covered with carpet
• Enclosure Dimensions: 20-11/16" D x 12-1/4" W x 7-1/8" H
(2)
$149.99
List price $169.99
•Comp 12" Sealed Down Firing Subwoofer Enclosure
• 12" Comp-Series Subwoofer
• 3/4" medium-density fiberboard construction covered with carpet finish
• Enclosure Dimensions: 22-7/8" D x 14-3/16" W x 7-7/8" H
$179.99
List price $199.99
Rockford Fosgate Prime R2S-1X10
• Dual 10" Sealed Subwoofer Enclosure
• Dual 2 ohm Impedance
• Spring-loaded Terminal Posts
• Enclosure Dimensions: 5.25" TD x 3.24" BD x 19" W x 13.5" H
(16)
$239.99
List price $239.99
Rockford Fosgate Punch P3S-1X12
• 400 Watts RMS
• 800 Watts Max
• Sealed Truck-Style Enclosure
• Kevlar Fiber Semi-Pressed Paper Cone
• M-Roll Santoprene surround
• StampCast basket with integrated spider venting
• 2.5" Dual 2 ohm Voice Coil with spun-laced Nomex insulating collar
• Dual linear spider with embedded 16 AWG tinsel leads
(8)
$409.99
List price $409.99
Rockford Fosgate Punch Shallow Loaded Enclosure P3S-1X10
• 300 Watts RMS
• 600 Watts Max
• Kevlar Fiber Semi-Pressed Paper Cone
• Compressed Sealed Poly-foam Surround
• ABS/Acrylic Dustcap Assembly
• 2.5" Voice Coil with spun-laced Nomex insulating collar
• 10 AWG compression speaker terminals
(4)
$369.99
List price $369.99
• Sealed enclosure with 2 12" Comp Series Subwoofer
• 300 watts RMS (600 watts Peak)
• Final Impedance: 2-ohm
• Dimensions: 32-3/8" L x 16" H x 17-1/4" W x 13-7/8" W2
(4)
$299.99
List price $329.99
Manufacturer:
Model Number:
T1D410, MDFS10, BBSW127
Weight:
43.65lbs
Internal SKU:
t1d410_mdfs10_bbsw127
Internal Product ID:
181683
| 5 star |
|
82% |
| 4 star |
|
14% |
| 3 star |
|
4% |
| 2 star |
|
0% |
| 1 star |
|
0% |
| Durability | ||
| Value | ||
| Features | ||
| Design | ||
| Usability |
As expected
Could have a better way to decide which wire to use as positive or negative. Only has spaced print on one wire.
158 found this helpful Helpful?
beau produit
Belva est une marque qui se rapproche de la marque stinger a premiere vue.bon produit.
152 found this helpful Helpful?
Great wire
This is some great speaker wire looks good works good and you get so much for so cheap
139 found this helpful Helpful?
High Quality Box!
I use this box for my Rockford Fosgate 10 and it sounds amazing in my hatch. Connectors felt solid, box felt solid. 100% recommend this!
126 found this helpful Helpful?
Great box for the $.
Dropped a RF prime In and sounds great. Well built. Great value.
128 found this helpful Helpful?
FREE box...
Box is well built, its hard to mess up building a small sealed box.. The only problem was sub opening wasn't large enough for my sub, 5 minutes with a jigsaw and vacumn took care of that though..
125 found this helpful Helpful?
Great Value!
Sturdy, fits like a glove not too big, not too small either. Can't make it for the amount they sell it.
126 found this helpful Helpful?
Decent Small Box
For the money it is a pretty good product. The carpet is a nice black. Very dark and very clean. The box is solid and can take a beating. The terminal cup is nice as its a binding post and not those crappy pressure tabs. Good box, decent sealing, good carpet.
125 found this helpful Helpful?
well built for price
i have a dvc pioneer 10" sub that fits perfectly in this box and sounds great. looks good in trunk and still gives me room to put stuff in it
125 found this helpful Helpful?
Nice enclosure
Not much can really be said about a sub enclosure, other than it does its job well. My Rockford Fosgate P1S2-10 fit in snuggly. The only thing that was a tad iffy was that when drilling once the bit went through it would catch of the inside insulation and mess it up, but quite honestly it didn't really bother me at all. Good enclosure.
116 found this helpful Helpful?
25 ft. of True 12 Gauge EnvyFlex Speaker Cable/Wire (100% Oxygen-Free Copper)
(50)
$29.99
List price $49.99
NVX Sound Dampening Trunk Kit (SDTK20)
20 Square Feet of Sound Dampening Material (Five 18" x 32" Pieces)
(114)
$59.99
List price $71.99
NVX Sound Dampening Rubber Roller (SDRLR1)
Universal, Professional Heavy Duty Roller for Sound Damping/Dampening
(117)
$10.99
List price $13.99
