See all parts that fit your 2012 Fit
1000 Watt (500W RMS) 10" VS-Series Dual 2-ohm Car Subwoofer
• 10" VS-Series Subwoofer
• Dual 2-ohm Voice Coil
• RMS Range: 350 - 500 Watts
• Non-Pressed Paper With Woven Carbon Fiber Top
• High Excursion Foam Surround
• Stamped Steel Basket
• Single Nomex Spider
• 10" VS-Series Subwoofer
• Dual 2-ohm Voice Coil
• RMS Range: 350 - 500 Watts
• Non-Pressed Paper With Woven Carbon Fiber Top
• High Excursion Foam Surround
• Stamped Steel Basket
• Single Nomex Spider
| Best Value! | ||
NVX VSW102V2$$79.99 |
![]() JL Audio 10W1v3-2$$249.99 |
|
|
RMS Power Rating |
500W | 500W |
|
Impedance |
Daul 2 ohm | Single 2 ohm |
|
Frequency Response |
20 - 200 Hz | 25 - 250 Hz |
|
Sensitivity |
87dB | 83.9 dB |
|
Dual Layer Voice Coil |
|
![]() |
|
CEA-2031 Compliant |
|
![]() |
| Xmax | 11 mm | 11 mm |
The NVX VS-Series subwoofers pack a massive punch when it comes to bass output. Their subwoofers are designed with a non-pressed paper cone and optimized PP dust cap for accurate response and extreme SPL. The high roll blended foam surround keeps the cone in place and is specially treated to give you maximum excursion. These subwoofers can offer up to 12mm of Xmax.
Each of NVX’s subwoofers is equipped with a 2.5” aluminum voice coil, providing maximum current distribution throughout your entire subwoofer. All VS-Series Subwoofers are also equipped with dual voice coils. Dual voice coil (DVC) subwoofers are popular amongst car audio enthusiasts because of the flexibility they offer. DVC subwoofers give installers more options on the way they wire their subs such as wiring each woofer in either series or in parallel.
What makes NVX VS-Series subwoofers stand out from other subwoofers on the market is the aluminum shorting ring. The ring is a conductive aluminum ring placed in the air gap between the pole piece and the voice coil to reduce inductance. This in turn reduces distortion and allows the subwoofer to accurately play a higher part of the bass spectrum. What this means for you is it provides more power delivery to the voice coils and improve the sound quality of your subwoofer. These features are typically found only in higher-end subwoofers but with our pocket-friendly price point, this makes it more accessible for you.
The NVX VS-Series subwoofer uses a Y30 High-Energy Ferrite Magnet to provide more power to your subwoofers. Their largest subwoofers in this series, the VSW154v2 and VSW152v2, have massive 100oz magnets. Because of this, these 15” subwoofers can handle up to 750W RMS! With all of these elements combined, the VS-Series subwoofers bring deep, rich bass to your vehicle. Hear what all the noise is about today!
NVX VSW102 Version 3 (VSW102v3)
1200W Peak (600W RMS) 10" VS-Series v3 Dual 2-ohm Car Subwoofer
Quantity: 1
Priced Individually
NVX XMDFP101
Single 10” Ported 3/4" (1.2 cubic ft) MDF Black Carpeted Subwoofer Enclosure (Made in the USA)
Quantity: 1
Best selling similar products
Manufacturer:
Model Number:
VSW102v2, XMDFP101
Weight:
38.53lbs
Internal SKU:
vsw102v2_xmdfp101
Internal Product ID:
193631
Solid Enclosure
This is a solid box. It really is 0.75” throughout. Very well constructed. Very rare find to get just over a net cubic foot for a prefab box in this price range. I’m giving it a 4/5 because it was tuned way too high for my taste. It’s tuned to around 44/45 hz. Luckily the Port width is 1.5 “ so I was able to tune it with a 2x4. See pic. It sounds fantastic.
61 found this helpful
Awesome
This little 10s are awesome. Have them ran on a vad1000.1 in a crappy prefab sealed box. Even underpowered and choked by the box they still manage to bang. They are suited for all types of music and sound great!
62 found this helpful
I'm insane
So I recently purchased 3 of these 10" subs and managed to squeeze them in a net 3.103 ft³ volume ported box in a standard cab 1994 f150 that's been heavily modified. At first, they had great bass and extension. Once they broke in, however, the great bass turned into phenomenal bass. They're running at 1.33 ohms on a skar rp2000.1d and are tuned to 25 Hz. I need better highs and mids now to keep up with them. Being in such a small cab space one wouldn't think the low-end extension would be great, but it hits hard all the way down to 10 Hz. The sound isn't just loud either. It is quite possibly the cleanest 10" subs on the market today. Absolutely no slop in bass transition from high notes to low notes and back. Tight and defined completely articulate for any style of music. 1000% recommendation to anyone looking to sound high-end without paying that ridiculous price tag.
59 found this helpful
Clean sounding 10!
I was actually impressed with the quality of the spider, cone, and the sub all around. Felt very sturdy and well built. Sounds very clean in the sealed box I placed it in. I plan on building a built to spec ported enclosure for it in the near future.
58 found this helpful
NVX VSW102v2 (VSW102 v2)
This sub does a good job I'm thinking about going to the next lvl time will tell with the NVX product line. Right now I'm pushing this amp with a Treo amp at 600RMS.
55 found this helpful
Goes hard, versatile too.
Once again, another NVX product has made me a happy man.
Sonic has also been really great throughout my order process.
54 found this helpful
Awesome sub woofers
I did a ton of research before spending my hard earned cash. And came upon this brand i never heard of before the NVX brand , so i did a bunch of reading about the brand and read all the reviews i could read , then i bought a pair of NVX 102v2 subs and they looked just as good in person as they did in the pictures . Then when i hooked them up i was very happy with the sound , even in a smaller ported box they sounded awesome , getting a better box very soon like next week can't wait to hear them in the right size box . I just know they will rattle my brains out lol. Would recommend these to anyone who loves music like i do
54 found this helpful
Pleasantly Surprised
Hefty subwoofer with modest specifications and surprising performance. I have been installing car electronics professionally for over 15 years, and this little gem did not disappoint me.
I installed one VSW102 v2 with an NVX BDA7501 amplifier and NVX one-farad capacitor. I built a 1.25 cu.ft. vented enclosure tuned to 32 Hz for the trunk of my Challenger. After a reasonable break-in period, the subwoofer has a punchy mid-bass and an impressive low-end. Very happy with this subwoofer. Get the matching grill for a protected, finished look.
53 found this helpful
Amazing sub!! And even better price
I have 2 10in subs wired to a rockford fosgate t1000.1 amp and they sound great. I will be adding and extra battery and cap so I can't wait to hear it once it's properly powered.
52 found this helpful
Impressed!
I put this in a .83 cubic foot ported box down firing, all I can say is wow! For a single 10" sub it really does a good job. Sound quality is very good and it HITS! Can't keep my mirror adjusted!
I love it and will consider NVX for my future needs!
52 found this helpful
Cancel
Modern vehicles often require specific brackets, wiring harnesses, and mounting solutions. A fit guide ensures:
Whether you're replacing a factory stereo or upgrading your entire audio system, the Fit Finder eliminates uncertainty.