Punch Series 2-Channel Class AB Car Amplifier • 50W x 2 chan. @ 4 ohms • 100W x 2 chan. @ 2 ohms • MOSFET power supply • RCA Pass-thru outputs
Overall rating distribution
By feature average rating
May 5, 2011
I've had this amp for a while and i run a single Rockford Fosgate Punch 12 with an 8 gauge and it never gave mw any problems, I've had two MTX's hooked up before this and they blew fast with a rating higher than the amp. Main thing I like about this amp is that I have bumped it for a whole our in the summertime and it never overheated. I like the design as well.
March 23, 2010
Without question, this amplifier offers the best bang for your system buck. The birthsheet for my amp reads 81 Watts x 2 @ 4 ohm. This amplifier is clean and looks good. I've been a sound quality competitor for 15 years and I've never purchased anything of this quality for so little. I'd expect the performance delivered to cost twice as much - and I'd willingly pay for it.
December 20, 2008
I would definitely recommend this amp to anyone who is buying an amp for their speakers, not so well with a high RMS sub. With my speakers it has never gone into thermal mode, even on my 7 hour trips. I have 8 speakers going through this one amp and my truck sounds amazing so. i would definitely recommend this product.
June 16, 2012
High quality amp for mids and highs
This little amp has been wonderful. I have it hooked up to two Kicker KS600 6.5" for my mids and highs in my daily driver.
It puts out well over rated power of 50 watts at 4ohms. Metered at 82 watts RMS at 4ohms so you have lots of headroom. I have my gain all the way down, it pushes these kickers to their max, and it sounds great doing it. Doesn't get warm at all, feels solid. I probably have enough clean juice to add a little 8 for mids if i wanted.
The connections look really clean you don't even see them, just the wire going to the amp, which also saves room, and it is very nice to not have to use any ring terminal connector etc for the power/ground/remote wires. Overall a very well designed amp, I recommend for anyone running up to roughly 1,500 watts of subwoofers. I'm running 1,000 watts clean on my subs and my mids and highs are borderline too loud for me with the gain all the way down. ;)
January 12, 2009
Not bad for the price.
We wired this amp bridged to two kenwood 12's and it sounded good, but when I turned the volume up loud the amp went into safe mode because there was too much power going through it. So we wired it straight up and it's not as loud but it does not cut out at all. Even the rock songs sound good on it, and rap is loud but nothing overwhelming. Overall a good amp if your looking to improve your sound and give it a little thump, but don't expect this thing to rattle your neighbors windows.
October 13, 2008
I bought this and hooked it up to 2 12" Rockford P3's and I thought that the subs wouldn't be good because of the amp. I was pretty wrong. pulling up next to someone is always fun now. I almost gave an old couple a heart attack the other day. Its a great amp and for this price, worth it.
March 17, 2012
Amazing little amp.
I bought this amp just as a temp amp to power my old Rockford Punch Z Subwoofer. Well, in around 3 1/2 to 4 hours, the sub blew. So now, it's running a 10" RF R2. Let me tell you, this amp packs quite a punch. They say it's only 200 watts max power bridged, but when you check out the birth sheet, it says 263 watts @ 4ohms bridged.
Best selling similar products
• RMS: 25W x 2 @ 4 ohms, 50W x 2 @ 2 ohms
• Total Peak Power: 100W
• CEA-2006 Compliant/Preamp Outputs/LPF
• 4"W x 3-1/4"D x 1-5/8"H
• RMS: 60W x 2 @ 4 ohms, 95W x 2 @ 2 ohms
• Total Peak Power: 500W
• CEA-2006 Compliant
• Dimensions: 9-1/2"W x 7"L x 2-1/2"H
• 2-Channel Class A/B Amplifier
• Speaker Level Inputs
• Up to 1000 Watts when Bridged
• Fully Adjustable Crossovers
• 50 Watts RMS x 2 @ 4 ohms
• 70 Watts RMS x 2 @ 2 ohms
• 130 Watts RMS x 1 @ 4 ohms
• Total Peak Power: 600 Watts
• High and Low Pass Filters
• 0-12dB Bass Boost
• Aluminum Heatsink
• Dimensions: 9.84" W x 9.44" L x 2" H
• RMS: 2 ohms: 700 watts x 2 chan.
• 2000W Max.
• Switchable Phase Shift
• Input Sensitivity Selector
• Remote Subwoofer Control
• Heavy-Duty Screw Terminals
• Chrome-Plated Connections
• Illuminated Logo
Internal Product ID: