Valet Switch for Clifford G4 Systems
Internal Product ID:
Clifford alarm by default, not by choice.
For whatever reason, Clifford chooses to make just about everything opposite from the norm. 1 chirp:disarm, 2 chirps:armed, wiring, etc.
I bought my truck with the alarm installed, but needed a new remote. But if I had a choice, I would have bought something else.
Other than that, it's an okay alarm.
Good product great value for money easy to use good features
It's always nice to have an extra
I purchased this as a spare valet switch. I have an older Clifford Intelliguard 9000. This is a "4G" system that was made back before Clifford was bought out by DEI and before their newer "5G" systems. This switch is compatible with both generations. The switch is used every time I start the car in order to enter the code which tells the alarm I'm authorized to drive (anti carjacking feature will kill the motor if not entered). It also allows full adjustment of the many alarm features without connecting to the Cliffnet wizard software. It gets a lot of use and I've gone through one replacement.
This product is temporarily out of stock. May we recommend...
•Universal bypass module for aftermarket stereos
• Emulates a parking brake signal
•ntended for use in RVs, off-road vehicles and exhibition vehicles: Other applications are illegal
• 5 normally closed trigger inputs
• 1 negative trigger output
• Solid-state, high current relay block
• LED Indicators
• Dual Zone Proximity Sensor
• Dual zone sensing
• Protects both inside and outside of the vehicle
• Each zone is independently adjustable
• LED sensitivity test light
• Pre-wired 4-pin plug allows easy connection to all Omega systems
• Mercury Tilt Switch
• Detects Open Zones
• Waterproof Design
• Adjustable Angle
Save up to 10 different vehicles in your garage