Cerwin-Vega VEGA104.2

jake 17 and bumpin

these things bump like crazy.
i built a box that is 5.2 cubic ft that is split in half with 2 on each side and 2 ports 4 inch big and 20 in deep in each chamber. i have a kenwood x1r with a kenwood kac-993 deck and it bumps so hard i can barely breath i have cerwin vega component speakers all around and a kac x4r amp to those and it is in a 99 malibu and these subs are by far the loudest i have heard they compete with the cars at comps easily i have them running at 2 ohm so they are getting 1200 watts rms power they are flexin tuff

Cerwin Vega 104

I ordered a Cervin Vega 104 From Sonic and it sounds great. It was shipped promptly and was as described! A+

Update to its good

I just finished building a bandpass for ONE of these subwoofers.
Its big....
The ported section is 1.2 cubic feet with a slot port about 2 inches wide by 10 inches tall by 11 inches long. The sealed section is exactly 1 cubic foot and is stuffed heavily with fill. This is where the magnet is. I know its somewhat backward, you are supposed to install the speaker so that its magnet is in the ported section for proper voice coil cooling, but I don't care.
I am pushing this subwoofer with a US Amp 800.2 in stereo mode, the left channel pushing one voice coil and the right channel pushing the other. Kicker power and ground wires. These amplifiers are highly underrated, so the sub is receiving at least 100 watts RMS to each coil, but oh well. Gain 1/3 the way up, bass boost 1/3 way up (centered at 40Hz). I went from two of these, each in 1.1 cubic feet sealed enclosures to just this one and - it - is - so - awesome...
I honestly cannot believe my ears. Its louder than when I had two in the sealed box.... JUST ONE IS deeper, much much deeper and louder. I am truly astonished. Also, the really low bass is very, very pronounced. Before, i could barely get the lift gate to my jeep cherokee to rattle, I had to push them hard. Now, everything rattles, the roof rack, doors, windows, i just can't get over this setup. I'm now building an identical box for the other.
This speaker is made for a bandpass with these or similar specs. All the other enclosures are nothing but compromises. Expect for midbass(I don't want that at all) this one hits every note and boy is it loud for being only 200 watts! Get two for a bandpass, give them about 200 watts RMS to each, and you'll be really happy! Hope this was helpful!

good

I recommend this because they do get loud in the right enclosure, with enough power. I'm feeding each voice coil about 75 watts RMS and it sound nice.
Pro: handles descent power, wiring possibilities with an additional CV DVC, can perform well in small enclosures and sound clean and deep in larger ones. And it looks cool!

Summary: Get at least two and feed them a true 450~500 watts RMS in a medium sealed enclosure and you'll love them

its good.

I have had this subwoofer in three different enclosure, manufacturer specs for sealed enclosure (.7cubic feet), for ported (1 cubic feet) and my own sealed(1.1 cubic foot) and mine sounds the best. The 1 cubic foot ported is loudest in its tuned frequency, but everything else is poor. Everything out of that set up sounds horrible. The.7cubic foot small sealed sounds pretty good but doesn't go low at all. BUT, my 1.1 sealed box gets loud, not as loud as the ported though. Mine goes lower than everything else and sounds the cleanest, but with about 1/3 less power handling. 150 watts rms in my box will push one to its limits without distortion. The .7 cubic foot one is a bit louder than mine, but its a trade off. I like the bass to go lower and i am willing to trade off a little spl to do so. I recommend this speaker cause its a DVC that can come with each coil in 2 ohms or 4 so it allows you to do more with it. Looks great in my opinion! I oprefer this one over kickers entry level subs, including the 12 incher. Yes, I prefer this ten over kickers entry level 12. 50 more watts RMS and its looks awesome

Cerwin Vega Mobile 10 Inch Woofer

I had this sub installed into my Vw Polo 6. I used a JVC Amplifier on bridge mode 120 rms to power this 200 rms sub, it sounded ok. I recently installed a starsound amplifier on bridge mode which equates to 350 rms at 6 ohms. These woofers now sound incredible and play like a 12 inch woofer. The bass gets deeper as you turn up the volume. There is no distortion, just deeper bass as you turn up the volume. I would strongly recommend this product. Get the right Amplifier and get a sealed box. You will not be disappointed. These subs can handle a powerful amplifier. I have my amplifier turned full and this sub plays strong.

Great Product

I had previously ordered the Cerwin Vega 10" Subs and fully Enjoy them. I had their predecessors and realy enjoyed them so decided to give Cerwin-Vega another shot, and couldn't be happier.

I have two of theses 10's in a downward sealed box in my extra cab Silverado. Even though they are under the backseat in a custom box, they put out some serious SPL.
These 10's are wired straight out from a 4 channel amp bridged amp. 2 channels are bridged together putting out probably 300 watts on channels 1+2(bridged), and channel 3+4(bridged). Sound GREAT

Great!

Full recommendation! Great deal for great price!

great stuff.

I instaled this in a .80 CuFt box downfire. running a hed500.1 amp, this thing hits hard...

CERWIN VEGA

This product is not good. Did not like it, I had 3 and it was not amazing at all.