PAC Car Amplifier Installation & Accessories

• Adjustable Line Output Converter
• Utilize Audio Transformer for Noise Isolation
• Compatible with 2 - 40 watts RMS of Radio Output

• Dash Mounted Amplifier Level Control for Volume Adjustment
• Perfect For Balancing the System to Change Music Styles
• Adjust Amplifier Gain While Driving

• RCA Noise Filter
• Close to perfect response of +/- .03 dB from 20 Hz - 20kHz
• Eliminates ground loop noise
• Reduces most noise

• 2-Channel LOC PRO Series
• Remote Turn on Wire
• Single Dial
• Signal-Sensing Circuit
• Surface Mount Construction
• Level Gain Adjustment

• Remote Turn-On Module
• Used To Turn On Remote Amplifiers
• 2 Second Delay To Prevent Turn-On Noise
• Supplies 2 Amps Of Current
• Can Drive Multiple Amps Or A Power Antenna
• Activated By Low Level Trigger Lead

• Video Unlock trigger module
• Unlocks video playback for aftermarket radios while vehicle is in motion
• Works with all popular brand radios like Pioneer, Kenwood, Alpine and more
• No Programming Required

• Remote Level Control
• Converts the speaker levels of a factory or aftermarket radio to RCA (pre-amp level)
• In-dash or under-dash mount control knob

• 4-Channel LOC PRO Series
• 33% Smaller Size Gives More Room For Vital Components
• 55 Watts Per Channel
• Speaker Level Input to RCA Level Output
• Single Dial

Tone Generator • Speaker Polarity Tester • Perfect Troubleshooting and Testing • Output Range of 0-8 Volts • Includes RCA and Alligator Clips • 9V Speaker Popper • Auto Shutoff

• Plug-and-play installation
• 5 channel RCA output
• Retains SYNC, Bluetooth audio and all warning chimes
• Non-fading level control knob

• Replacement/Addition Of Amp In 1997-2004 Chevrolet Corvette With Premium Delco/Bose Sound System
• 4 Channel Interface
• 16/18 Pin

• Converts 10 to 30 watts per channel with a fixed 10:1 conversion
• Great for getting an additional set of pre-amps outputs from a head unit equipped with only one set

• Signal sensing turn-on circuit allows for easy addition of aftermarket amps to factory stereos
• 10 volt RCA pre-amp output
• Surface Mount Technology
• Ultra low 50m ohm output and 20 ohm input impedance helps eliminate noise

4-Channel LOC PRO Series • Remote Turn on Wire • Single Dial • Signal-Sensing Circuit • Surface Mount Construction • Level Gain Adjustment

• Works with PAC AmpPRO: AP4-FD11 and AP4-FD21
• 10 feet
• Provides a plug-n-play connection

• Ground Loop Isolator
• Close to Perfect Response of +/- 0.03 dB From 2-20,000 Hz
• Utilizes Proprietary Audio Transformers for a 1.3 dB Gain
• Female 3.5mm Input
• Male 3.5mm Output

• 2-Channel LOC PRO Series
• 33% Smaller Size Gives More Room For Vital Components
• 55 Watts Per Channel
• Configurable For Speaker Level or RCA Input/Output
• Single Dial

• Plug-and-play installation
• 5 channel RCA output
• Retains SYNC, Bluetooth audio and all warning chimes
• Non-fading level control knob

• Simplifies Amplifier Installation
• Prevents Need For Summing and DSP Devices
• Provides Factory Sound System Upgrade Solution

• Plug-and-play installation
• 5 channel RCA output
• Retains SYNC, Bluetooth audio and all warning chimes
• Non-fading level control knob