InstallBay Complete 0 Gauge Dual-Amp Kit (AK01)

Worked for what I needed

This is a good cheap kit for someone on a budget. I would not run this in a car built for competition as it is not true 0Ga. It is a little bigger than 4Ga just not 0Ga. All of the blocks and fuses seem to be built well. No complaints.

Not bad

Its not the best but it does the job. I like it because of all the accessories it comes with not the quality of wire.

Not bad

The actual wire is not all that thick, and its just copper coated. Typical low end gear but it gets the job done. My only complaint is the ground wire is smaller than power so i just used a small part of the power wire for grounding.

great buy

I got this kit, installed and works fine. Cant beat the price

VERY HAPPY

after searching for hours I found this installation kit which seemed to be the best deal out there and when I received it i found that I was correct, very good quality and I have no idea how they shipped it to me so fast, and at xmas time! The kit includes absolutely everything you need to install a couple 1,000 watt amps.

Size

The only down size to these is the fact that they are not 1/0 that they say they are but other than that everything is of good build. I also just have these running about 900-1000rms after I add one more amp then it will be up too 1200-1300rms. Going a little bit bigger than what you need is all ways a good idea sense it just allows the pwr move in an easier fashion I noticed the voltage meter on my truck to not pull as much when it was running proof enough for me.

Awesome install kit

Comes with everything you need and more at a great price.

very nice

This things works great. I have never had trouble with under powering my system. Very clean and nice package.

I will recommend the kit

There is all you need to install the 2 amps in this kit sufficient wire I compared the thickness of the wire ( not the outside plastic ) to some of my friends 1/0 gauge kits more expensive at 200 Dlrs and the thickness is the same. And is not oxygen free .. My only disappointment is the fuse box They su ck. I needed to add tape to keep them close. That's all

good deal

Good setup but the RCa jacks need to be not as flexible. My prongs broke just from disconnecting them from the amp.